![]() ![]() ![]() While adding the second drive is possible without removing the logic board, you will not be able to align the screws with the chassis (and will crush the grommets in doing so). The entire process took me about 1 hour, but it all depends on your level of proficiency. I had data on my secondary drive and saw my boot sequence lengthened to minutes as a result. One thing to note, after you've installed the drive, reset the PRAM/NVRAM to ensure a problem free experience. Macrumors has a thread outlining the process, and that can be supplemented with iFixit's own guide. It depends entirely on the level of craftsmanship you possess. And since the unit is likely to stay stationary, not a large concern. In any case, the grommets and screws are not entirely necessary as the limited room stops the drive from thrashing around. The ones provided in the iFixit kit are not OEM, but just aftermarket screws that meet the dimensions. The screws are standard " headless screws". I had to shave a bit off to make them thinner, but they work beautifully. If you have no qualms about spending the extra dough for what is likely a one-time affair, then by all means.ĭo note that you can pick the grommets from Home Depot (they are 1/4" grommets) on the cheap. The iFixit kit includes the logic board puller, but I used two small screw drivers, which work just the same. I purchased mine from PowerbookMedic for $29.95 and a few dollars shipping/handling. IFixit has a kit you can purchase (see image below), or you can readily just buy the flex cable (PART# 922-9560). You can install any drive, provided it's of the 2.5" variety (notebook disk). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |